Why Mix Your Own Developer from Raw Chemicals?
Mixing your own film developer from raw chemicals gives you control over the formula and lets you adjust the grain and contrast to suit your film. Bellini supplies the individual ingredients—like borax and sodium thiosulphate—in measured quantities so you can start with a proven recipe. This guide walks through mixing the Adox M-Q Borax Fine Grain Film Developer using Bellini raw chemicals.
How to Mix the Adox M-Q Borax Fine Grain Developer
The recipe below is supplied with the Bellini Borax product record. Mix the chemicals in the order listed, dissolving each completely before adding the next.
- Weigh and mix the dry chemicals: Measure 2 g Metol, 80 g Sodium Sulphite (anhydrous), 4 g Hydroquinone, 4 g Bellini Borax, and 0.5 g Potassium Bromide. Dissolve them in water following the supplied product instructions to prepare the solution.
- Use full strength: The developer is used full strength—no dilution. Development times are typically 10%–20% longer than D76/ID-11, according to the supplied evidence for Bellini Borax.
Key Ingredients from Bellini
- Bellini Borax - 200g: Borax, also known as sodium borate, is a mild alkali/accelerator for fine grain developers. The supplied recipe uses 4 g per liter. Borax acts as the accelerator in this fine-grain formula, controlling development speed and grain structure.

Bellini Borax - 200g - Bellini Sodium Thiosulphate Pentahydrate - 1kg: Sodium Thiosulphate Pentahydrate (Hypo) is a standard fixing agent. This 'penta' version contains 33% water and is used in the fixer bath, not the developer. While not part of the developer itself, you need a fixer to complete the film processing. Bellini's sodium thiosulphate is the correct chemical for that step.

Bellini Sodium Thiosulphate Pentahydrate - 1kg
Important Notes on the Recipe
The supplied evidence for Bellini Borax states that development times are typically 10%–20% longer than D76/ID-11. This is a general guideline; your specific film and agitation method may require adjustment. The catalog does not provide exact times for every film, so start with a test roll.
Mixing raw chemicals requires accuracy. Use a precision scale (0.1 g resolution) and distilled water. Always add chemicals to water, not the reverse, and stir until fully dissolved.



